Would you like to learn how to install a water towel rail?
In this post we show you how to install a water towel dryer easily and effectively.
Rointe water towel radiators: efficiency and comfort
Rointe’s water towel dryers are designed to offer energy efficiency and maximum comfort.
Its operation is simple: the water heated by a generator circulates continuously inside the towel rail, regulating its flow for fast and long-lasting heating. Follow these simple steps to install it correctly.
Tools needed to install a water towel dryer:
- Wrench.
- Drill and drill bits.
- Pencil.
- Screwdriver.
- Plugs with reduction to 1/2″.
- Purger with reduction to 1/8″.
- Blind plugs.
- Gaskets to seal the plugs.
- Supports for fixing the towel rail.
- Valves to open and close the water passage.
- Traps to expel air from the installation.
Important note: Make sure you know the diameter of the pipe installed (16, 18, 20, or 22 mm).
Steps to install a water radiator-towel dryer
- Towel rail location:
Install it where there are nearby pipes or create a facility to connect the systems. Identify the boiler’s flow pipe (the one that heats up first). - Turn off the boiler and water supply:
Keep intake valves open. - Place the trap:
Place it on top of the towel rail. If it’s automatic, install it as a plug; If manual, use it only to release air from the circuit. - Install the inlet valve:
Place it on the bottom of the towel rail, at one end. - Set the stopper:
Place it at the bottom of the opposite side to ensure proper water circulation. - Adjust the ground clearance:
Make sure the towel rail is 10-15 cm from the floor. - Connect the water intakes:
Attach the towel rail to the wall and connect the valve and detentor to the water outlets on the wall. - Purge the system:
Remove any accumulated air in the pipes to ensure that the towel dryer is working properly.
Towel dryer maintenance
Remember to clean your towel dryer at least once a year! This will prevent malfunctions and ensure optimal performance.
